Attach The Power/Data Cable To The Validator

If your printer is configured for Peel-Off Media Handling mode (use of optional internal rewinder), you may need to align the beam further behind the notches (0.20 to 0.30 inches [5.08 mm to

7.62mm] from the front edge of the tear bar) so that the peeled label remains on the tear bar and the trailing edge of the last bar code can still pass completely under the scanning beam. See Figure 13.

0.30inches

7.62mm

Figure 13. Aligning the Scanning Beam – Peel-Off Media Handling Mode

If your printer has a cutter installed, align the beam with the notches at each side of the opening on the hinged upper lid, as shown in Detail A of Figure 14.

A

Scanning Beam

A

Notch in Tear Bar/

Cutter

Figure 14. Aligning the Scanning Beam – Cutter Installed

29

Page 29
Image 29
Printronix T5000e Series user manual Aligning the Scanning Beam Peel-Off Media Handling Mode