Carrier Access none manual Snmp-server community, Snmp-server enable, Server-src-port

Global Configuration Mode

Global Configuration Commands

server-src-port

Defines the server source/destination port. Syntax:

server-src-port {portport-portany} server-dst-port {portport- portany}

server-src-port	port - Enter the server source port to apply the service to.
	port-port- Enter a range of ports to apply the service to.
	any - Apply to any port.
server-dst-port	port - Enter the server destination port to apply the service to.
	port-port- Enter a range of ports to apply the service to.
	any - Apply to any port.

Example: (config)# service id 5 name test description desc1 protocol gre

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

snmp-server

The following are the commands to set the SNMP server configuration. To disable SNMP, see no snmp- server command on page 4-50.

snmp-server community

Use the snmp-server community command to set the SNMP community name.

Syntax: (config)# snmp-server community community-name{rorw}

Field	Definition
community-name	Enter the SNMP Community Name.
ro	Read only - Set the community name to read only permission.
rw	Read write - Set the community name to read and write permission.

Example: (config)# snmp-server community communitytestname ro

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

snmp-server enable

Use the snmp-server enable command to enable SNMP on the system.

Syntax: (config)# snmp-server enable

Example: (config)# snmp-server enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

4-60 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI