Carrier Access none manual Encryption

Configuration - IPSec Mode

encryption

Use the IPSec encryption command to specify an encryption algorithm. To disable encryption, see no group command on page 14-13.

Syntax: (config-ipsec {n})# encryption {des3desaesaes192aes256}

Field	Definition
des	Set to 56-bit Data Encryption Standard (DES).
3des	Set to 168-bit DES. Default.
aes	Set 128-bit Advanced Encryption Standard (AES) as the encryption
	algorithm.
aes192	Set 192-bit AES as the encryption algorithm.
aes256	Set 256-bit AES as the encryption algorithm.

Example: (config-ipsec-1)# encryption aes192

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

end

Use the end command to exit the current configuration mode, and must be used to mark the end of any configuration file. This command can be entered in any configuration mode with the same result.

Syntax: (config-ipsec {n})# end

Example: (config-ipsec-1)# end

#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

exit

Use the exit command to close your current connection if you are in the User mode, or Privileged mode. If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you to the next higher level (example: back to Privileged mode from Interface configuration mode).

Syntax: (config-ipsec {n})# exit

Example: (config-ipsec-1)# exit

(config)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 14-5