Carrier Access none manual Syntax config-vlan# tag-all disableenable

Configuration - VLAN Mode

tag-all

Use the VLAN tag-allcommand to enable dot1q tagging for all ports.

If VLAN tagging is enabled on all ports, an ingress port should forward any untagged or priority tagged frames with a VID equal to the ingress port’s PVID and set the priority of the untagged frame to that of the ingress port. The priority of the tagged frame remain unchanged. See the port-prioritycommand, on page 20-5,to set the priority of the port.

Note: Ingress port is a port receiving frames from a source external to the switch. Egress port is a port forwarding frames to another port(s) in the switch.

Syntax: (config-vlan)# tag-all {disableenable}

Field	Definition
disable	Disable dot1q for all ports. Default.
enable	Enable dot1q for all ports.

Example: (config-vlan)# tag-all enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

vlan-feature

Use the VLAN mode vlan-featurecommand to enable/disable the VLAN feature on the device.

Note: This command is not visible on the Adit 3500 or MSR, as VLAN is always enabled on these products.

Syntax: (config-vlan)# vlan-feature {disableenable}

Field	Definition
disable	Disable VLAN feature.
enable	Enable VLAN feature.

Example: (config-vlan)# vlan-feature enable

Supported Platforms: Adit 3104, Adit 3200

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 20-7