Carrier Access none manual Show ip ospf database

User Mode

show ip ospf database

Use the show ip ospf database command to display information related to the OSPF database for a specific router. The various forms of this command deliver information on defined OSPF link state advertisements.

Syntax: > show ip ospf database						{setting}
Syntax: > show ip ospf database						{adv-router addressself-originate}
Syntax:	>	show	ip	ospf	database	network link-state-id
Syntax:	>	show	ip	ospf	database	router {link-state-idadv-router
	addressself-originate}

Syntax: > show ip ospf database summary [link-state-id] [adv-router addressself-originate]

Field	Definition
adv-router address	Displays all the LSAs of the specified router. If no IP address is
	entered, the local router information will be displayed (same as self-
	originate).
link-state-id	Portion of the Internet environment that is being described by the
	advertisement. The value entered depends on the advertisement's LS
	type. It must be entered in the form of an IP address. When the link
	state advertisement is describing a network, the link-state-id can take
	one of two forms:
	1. The network's IP address (as in type 3 summary link advertisements
	and in autonomous system external link advertisements).
	2. A derived address obtained from the link state ID. (Note that
	masking a network links advertisement's link state ID with the
	network's subnet mask yields the network's IP address.)
	When the link state advertisement is describing a router, the link state
	ID is always the described router's OSPF router ID.
	When an autonomous system external advertisement (LS Type = 5) is
	describing a default route, its link state ID is set to Default Destination
	(0.0.0.0).
network	Displays information only about the network LSAs.
router	Displays information only about the Router LSAs.
self-originate	Displays only self-originated LSAs (from the local router).
summary	Displays information on.ly about the summary LSAs.

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 2-19