Carrier Access none manual No firewall, No ip address, No ip default-route, No ip dhcp

Configuration - Ethernet Interface Mode

no commands

no firewall

Use the no firewall command to disable the configured firewall. To enable the firewall, see firewall command on page 11-4.

Syntax: (config-int-eth-{n})# no firewall

Example: (config-int-eth-1)# no firewall

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip address

Use the Ethernet Interface no ip address command to remove the IP address from the alias. To set the Ethernet IP address, see ip address command on page 11-6.

Syntax: (config-int-eth-{n})# no ip address address

Field	Definition
address	Enter the IP address to remove.

Example: (config-int-eth-1)# no ip address 192.168.1.100

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip default-route

Use the Ethernet Interface no ip default-routecommand to disable the default route. To set the default IP address, see ip default-routecommand on page 11-7.

Syntax: (config-int-eth-{n})# no ip default-route

Example: (config-int-eth-1)# no ip default-route

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip dhcp

Use the Ethernet Interface no ip dhcp command to disable the use of DHCP options 66 and 67 to autoconfigure the system. To enable DHCP, see ip dhcp command on page 11-7.

Syntax: (config-int-eth-{n})# no ip dhcp auto-provision

Example: (config-int-eth-1)# no ip dhcp auto-provision

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 11-17