Carrier Access none manual Host-filter, Interface ethernet, Network-object

Global Configuration Mode

Global Configuration Commands

host-filter

Use the host-filtercommand to configure the IP/host name filtering entries. To delete a host filter, see no host-filtercommand on page 4-40.

Syntax: (config)# host-filter id filter-id{ip-address addresshostname hostname} apply-to {lannetwork-object object-id} time-range {alwaysschedule-id}

Field	Definition
filter-id	Enter a filter ID name.
address	Enter the host IP address.
hostname	Enter a host name for the rule.
lan	Apply the filter the LAN interface.
network-object	Apply the filter to a defined network object.
object-id
always	Set the time range to always.
schedule-id	Enter defined schedule ID name with schedule to apply to this filter.

Example: (config)# host-filter id filterID ip-address 192.168.1.100 apply-to lan time-range always

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

interface ethernet

Use the interface ethernet command to allow access to the Ethernet interface configuration commands. See Chapter 11, Configuration - Ethernet Interface Mode for commands in this mode.

Syntax: (config)# interface ethernet port

Field

port

Definition

Ethernet port. Range 1-2.

Example: (config)# interface ethernet 1

(config-int-eth-1)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-19