Carrier Access none manual Fax-protocol-t38 ecs, Fax-protocol-t38 redundancy, Hs-redundancy

Configuration - Voice Service SIP Mode

fax-protocol-t38 ecs

Use the Voice Service SIP fax-protocol-t38 ecs command to configure the fax Error Correction Scheme parameter.

Note: For the MSR, T.38 will be supported in a future release.

Syntax: (config-voice-serv-sip)# fax-protocol-t38 ecs {noneredundant}

Example: (config-voice-serv-sip)# fax-protocol-t38 ecs redundant

Syntax Descriptions:

Variable	Definition
none	Set error correction to none.
redundant	Set error correction to redundant. Default.

Supported Platforms: Adit 3104, Adit 3500, MSR

fax-protocol-t38 redundancy

Use the Voice Service SIP fax-protocol-t38 redundancy command to set the T.38 protocol high and low speed redundancy.

Note: For the MSR, T.38 will be supported in a future release.

Syntax: (config-voice-serv-sip)# fax-protocol-t38 {hs-redundancy value}ls-redundancy value}

Example: (config-voice-serv-sip)# fax-protocol-t38 hs-redundancy 1

Syntax Descriptions:

Variable	Definition
hs-redundancy	Configures the number of duplicate packets to transmit during a high-speed
	T.38 fax call. Note: Setting the HS Redundancy to greater than 0 will cause a
	significant increase in the network bandwidth consumed by the fax call.
	Range 0-3 packets, with a default of 0 packets (no redundancy).
ls-redundancy	Configures the number of duplicate packets to transmit during a
	low-speed T.38 fax call machine protocol.
	Range 0 to 4 packets (0 = no redundancy), with a default of 3 packets.

Supported Platforms: Adit 3104, Adit 3500, MSR

25-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI