Carrier Access none manual Example config-dpeer-trk# codec preference 1 g711alaw

Configuration - Dial Peer Trunk Mode

codec preference

Use the Dial Peer codec preference command to set the codec preferences used to establish the codec list offered during media negotiation. To delete a preference, see no codec preference command on page 9-6.

Syntax: (config-dpeer-trk)# codec preference {123} {g711alaw g711ulawg729}

Field	Definition
123	Enter the preference number. #1 being the first preference.
g711alaw	Set the codec preference to G.711 A-law.
g711ulaw	Set the codec preference to G.711 U-law.
g729	Set the codec preference to G.729.

Example: (config-dpeer-trk)# codec preference 1 g711alaw

Supported Platforms: Adit 3500, MSR

destination-pattern

Use the Dial Peer destination-patterncommand to assign dial patterns to the trunk. To delete a pattern, see no destination-patterncommand on page 9-6.

Syntax: (config-dpeer-trk)# destination-pattern dest-pattern

Field	Definition
dest-pattern	Enter the phone number pattern that must be matched for calls to be
	routed to the trunk. Use ? as a wildcard that can be replaced with any
	single digit. Use $ as a wildcard that can be replaced with multiple
	digits (all digits following the $ are ignored).

Example: (config-dpeer-trk)# destination-pattern 555$

Supported Platforms: Adit 3500, MSR

9-2 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI