Carrier Access none manual Adit 3000 Rel .6 and MSR Card Rel 2.0 CLI

Configuration - L2TPC Mode

ip ospf authentication

Use the L2TPC ip ospf authentication command to enable the authentication method (either message- digest or simple authentication) for this interface. To remove the authentication type for this interface set the parameter to null or see no ip ospf authentication command on page 15-14.

Note: If an optional parameter is not entered, the authentication method of simple authentication is applied to the interface.

Syntax: (config-l2tpc-{n})# ip ospf authentication [message-digest null]

Field	Definition
message-digest	Optional parameter. Enables MD5 Authentication on the area.
null	Optional parameter. No authentication is used. Note: This is useful for
	overriding password or message-digest authentication if configured
	for an area.

Example: (config-l2tpc-1)# ip ospf authentication message-digest

Note: The authentication key must be defined before this command is implemented.

Therefore if setting simple authentication:

Example: ip ospf authentication-key pass777

ip ospf authentication

Therefore if setting message-digest:

Example: ip ospf message-digest-key 1 md5 pass777

ip ospf authentication message-digest

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

15-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI