Carrier Access none manual Syntax config-pptpc-n# no ip address address

Configuration - PPTPC Mode

no commands

no firewall

Use the PPTP Client no firewall command to disable the configured firewall. To enable the firewall, see firewall command on page 17-3.

Syntax: (config-pptpc-{n})# no firewall

Example: (config-pptpc-1)# no firewall

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip address

Use the PPTP Client no ip address command to remove the IP address assigned to the port. To set the Serial IP address, see ip address command on page 17-5.

Syntax: (config-pptpc-{n})# no ip address address

Field	Definition
address	Enter the IP address to remove.

Example: (config-pptpc-1)# no ip address 192.168.1.100

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip default-route

Use the PPTP Client no ip default-routecommand to disable the default route. To set the default IP address, see ip default-routecommand on page 17-5.

Syntax: (config-pptpc-{n})# no ip default-route

Example: (config-pptpc-1)# no ip default-route

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf authentication

Use the PPTP Client no ip ospf authentication command to disable the authentication method for this serial interface. To enable the authentication type for this interface see ip ospf authentication command on page 17-6.

Syntax: (config-pptpc-{n})# no ip ospf authentication

Example: (config-pptpc-1)# no ip ospf authentication

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 17-13