Carrier Access none manual Port-trigger service, Pptpc, Pptps

Global Configuration Mode

Global Configuration Commands

port-trigger service

Use the port-trigger service command to configure the port-triggering entries. To delete a port trigger service, see no port-trigger-servicecommand on page 4-45.

Syntax: (config)# port-trigger service name enable

Field

name

Definition

Enter service name.

Example: (config)# port-trigger service service2 enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

pptpc

Use the pptpc command to allow access to the VPN PPTP Client configuration commands. See Chapter 17, Configuration - PPTPC Mode for commands in this mode. To delete an existing connection, see no pptpc command on page 4-45

Syntax: (config)# pptpc {pptpc connection-idaddress address}

Field	Definition
connection-id	Enter the name of a connection. Range is 0-99.
address	Enter a destination IP address.

Example: (config)# pptpc pptpc 1

(config-pptpc-1)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

pptps

Use the pptps command to allow access to the VPN PPTP Server configuration commands. See Chapter 18, Configuration - PPTPS Mode for commands in this mode.To delete an existing connection, see no pptpc command on page 4-45.

Syntax: (config)# pptps

Example: (config)# pptps

(config-pptps)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-53