Carrier Access none manual Remote-admin telnet, Remote-admin udp-trace, Primary-port

Global Configuration Mode

Global Configuration Commands

remote-admin telnet

Use the remote-admin telnet command to allow remote administration via Telnet. To deny telnet remote access, see no remote-admin telnet command on page 4-47.

CAUTION! ALLOWING REMOTE ADMINISTRATION IS A SECURITY RISK.

Syntax: (config)# remote-admin telnet {primary-port primary-secure-portsecondary-port} {port portenable}

Field	Definition
primary-port	Primary Telnet port, default port 23
primary-secure-	Secure Telnet over SSL port, default port 992
port
secondary-port	Secondary Telnet port, default port 8023
port	Enter a specific port to change from default ports listed above.
enable	Enable port on telnet remote admin.

Example: (config)# remote-admin telnet primary-port enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

remote-admin udp-trace

Use the remote-adminudp-tracecommand to allow UDP traceroute queries. To deny UDP traceroute queries, see no remote-adminudp-tracecommand on page 4-47.

CAUTION! ALLOWING REMOTE ADMINISTRATION IS A SECURITY RISK.

Syntax: (config)# remote-admin udp-trace enable

Example: (config)# remote-admin udp-trace enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-55