Carrier Access none manual No ip ospf message-digest-key

Configuration - Serial Interface Mode

no ip ospf message-digest-key

Use the Serial Interface no ip ospf message-digest-keycommand to remove an old MD5 key. To enable OSPF MD5 (Message-Digest) authentication, see ip ospf message-digest-keycommand on page 13-9.

Syntax: (config-int-ser-{n})# no ip ospf message-digest-key key-id

Field

key-id

Definition

Enter an ID for this key. Range is 1-255.

Example: (config-int-ser-1)# no ip ospf message-digest-key 1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf priority

Use the Serial Interface no ip ospf priority command to set the router priority to the default setting of priority 1. To set the router priority, which determines the designated router for this network, see ip ospf priority command on page 13-10.

Syntax: (config-int-ser-{n})# no ip ospf priority

Example: (config-int-ser-1)# no ip ospf priority

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf retransmit-interval

Use the Serial Interface ip ospf retransmit-intervalcommand to restore the default value of 5 seconds. To define the interval of time between link state advertisement retransmissions for adjacencies belonging to the interface, see ip ospf retransmit-intervalcommand on page 13-10.

Syntax: (config-int-ser-{n})# no ip ospf retransmit-interval

Example: (config-int-ser-1)# no ip ospf retransmit-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf transmit-delay

Use the Serial Interface no ip ospf transmit-delaycommand to restore the default value of 1 second. To define the estimated time to transmit a link state update packet on the interface, see ip ospf transmit-delaycommand on page 13-10.

Syntax: (config-int-ser-{n})# no ip ospf transmit-delay

Example: (config-int-ser-1)# no ip ospf transmit-delay

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 13-17