Carrier Access none manual Syntax config-l2tpc-n# no ip route dest-ip-addr gateway

Configuration - L2TPC Mode

no ip ospf transmit-delay

Use the L2TPC no ip ospf transmit-delaycommand to restore the default value of 1 second. To define the estimated time to transmit a link state update packet on the interface, see ip ospf transmit- delay command on page 15-9.

Syntax: (config-l2tpc-{n})# no ip ospf transmit-delay

Example: (config-l2tpc-1)# no ip ospf transmit-delay

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip primary-dns

Use the L2TPC no primary-dnscommand to disable the primary DNS. To set the DNS primary IP address, see ip primary-dnscommand on page 15-10.

Syntax: (config-l2tpc-{n})# no ip primary-dns

Example: (config-l2tpc-1)# no ip primary-dns

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip rip

Use the L2TPC no ip rip command to disable RIP on this interface. To enable RIP, see ip rip command on page 15-10.

Syntax: (config-l2tpc-{n})# no ip rip

Example: (config-l2tpc-1)# no ip rip

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip route

Use the L2TPC no ip route command remove an IP route. To add a route, see ip route command on page 15-11.

Syntax: (config-l2tpc-{n})# no ip route dest-ip-addr gateway

Field	Definition
dest-ip-addr	Enter destination IP address to remove.
gateway	Enter gateway IP address to remove.

Example: (config-l2tpc-1)# no ip route 192.168.100.200 192.168.100.254

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 15-17