Carrier Access none manual Adit 3104 and Adit 3200 1.1, 1.2, 1.3, 1.4, Adit 3500 and MSR 1.1

Configuration - VLAN Mode

port-dot1q

Use the VLAN port-dot1qcommand to enable dot1q tagging for the port. If VLAN tagging is enabled on a port, the port will forward any untagged or priority tagged frames with a VID equal to the ingress port’s PVID and the priority of the tagged frame will remain unchanged. See the port-prioritycommand, on page 20-5,to set the priority of the port.

Note: Ingress port is a port receiving frames from a source external to the switch. Egress port is a port forwarding frames to another port(s) in the switch.

To clear the dot1q for the port, see no port-dot1qcommand on page 20-4.

Syntax: (config-vlan)# port-dot1q ethernet port

Field

port

Definition

Ethernet port in the form {port}.{sub-interface}. Adit 3104 and Adit 3200: 1.1, 1.2, 1.3, 1.4, 2.1 Adit 3500 and MSR: 1.1 and 2.1

Example: (config-vlan)# port-dot1q ethernet 1.1

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

port-priority

Use the VLAN port-prioritycommand to set the VLAN priority for the port.

Syntax: (config-vlan)# port-priority ethernet port priority

Field	Definition
port	Ethernet port in the form {port}.{sub-interface}.
	Adit 3104 and Adit 3200: 1.1, 1.2, 1.3, 1.4, 2.1
	Adit 3500 and MSR: 1.1 and 2.1
priority	Set priority level. Range = 0 - 7. Default is 0.

Example: (config-vlan)# port-priority ethernet 1.1 0

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 20-5