Carrier Access none manual Adit 3000 Rel .6 and MSR Card Rel 2.0 CLI 12-17

Configuration - Multilink Interface Mode

no ip ospf retransmit-interval

Use the Multilink Interface ip ospf retransmit-intervalcommand to restore the default value of 5 seconds. To define the interval of time between link state advertisement retransmissions for adjacencies belonging to the interface, see ip ospf retransmit-intervalcommand on page 12-10.

Syntax: (config-int-mlink-{n})# no ip ospf retransmit-interval

Example: (config-int-mlink-1)# no ip ospf retransmit-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf transmit-delay

Use the Multilink Interface no ip ospf transmit-delaycommand to restore the default value of 1 second. To define the estimated time to transmit a link state update packet on the interface, see ip ospf transmit-delaycommand on page 12-10.

Syntax: (config-int-mlink-{n})# no ip ospf transmit-delay

Example: (config-int-mlink-1)# no ip ospf transmit-delay

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip primary-dns

Use the Multilink Interface no primary-dnscommand to disable the primary DNS. To set the DNS primary IP address, see ip primary-dnscommand on page 12-11.

Syntax: (config-int-mlink-{n})# no ip primary-dns

Example: (config-int-mlink-1)# no ip primary-dns

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip rip

Use the Multilink Interface no ip rip command to disable RIP on this interface. To enable RIP, see ip rip command on page 12-11.

Syntax: (config-int-mlink-{n})# no ip rip

Example: (config-int-mlink-1)# no ip rip

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-17