Carrier Access none No digit-map global, Pattern number, Rtp value hex-value, Sip value hex-value

Configuration - Voice Port Mode

no digit-map (global)

Use the Voice Port no digit-mapcommand to remove a digit map pattern. To configure digit map, see digit-map (global) command on page 22-2.

Syntax: (config-vport)# no digit-map pattern number

Field	Definition
pattern number	Enter pattern number to remove. Range is 1-30.
	See show digit-mapcommand on page 3-37,to display the current list
	of Digit Map numbers.

Example: (config-vport)# no digit-map pattern 10

Supported Platforms: Adit 3104, Adit 3500, MSR

tos

Use the Voice Port tos command to set the Type of Service (ToS). This command sets the precedence bits in the TOS byte of the IP header to prioritize packet handling.

Syntax: (config-vport)# tos {rtp value hex-valuesip value hex-value}

Field	Definition
rtp value hex-value	Range is 0x00	- 0xff. Default 0xb8
sip value hex-value	Range is 0x00	- 0xff. Default 0xdc

Example: (config-vport)# tos rtp 0xb8

Supported Platforms: Adit 3104, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 22-5