Carrier Access none manual Syntax config-l2tpc-n# metric metric, Example config-l2tpc-1# metric

Configuration - L2TPC Mode

metric

Use the L2TPC metric command to configure the Metric of the IP network on this interface.

Syntax: (config-l2tpc-{n})# metric metric

Field	Definition
metric	Range is 0-255, with a default is 10.

Example: (config-l2tpc-1)# metric 150

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no commands

no firewall

Use the L2TPC no firewall command to disable the configured firewall. To enable the firewall, see firewall command on page 15-3.

Syntax: (config-l2tpc-{n})# no firewall

Example: (config-l2tpc-1)# no firewall

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip address

Use the L2TPC no ip address command to remove the IP address assigned to the port. To set the Serial IP address, see ip address command on page 15-5.

Syntax: (config-l2tpc-{n})# no ip address address

Field	Definition
address	Enter the IP address to remove.

Example: (config-l2tpc-1)# no ip address 192.168.1.100

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 15-13