Carrier Access none manual Adit 3000 Rel .6 and MSR Card Rel 2.0 CLI 15-15

Configuration - L2TPC Mode

no ip ospf dead-interval

Use the L2TPC no ip ospf dead-intervalcommand to reset the interval of time to the default setting of 40 seconds. To define the interval of time that no hello packets have been seen before neighbors declare the router down, see ip ospf dead-intervalcommand on page 15-7.

Syntax: (config-l2tpc-{n})# no ip ospf dead-interval

Example: (config-l2tpc-1)# no ip ospf dead-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf disable

Use the L2TPC no ip ospf disable command to enable OSPF processing on this interface. To disable OSPF on this interface, see ip ospf disable command on page 15-8.

Syntax: (config-l2tpc-{n})# ip ospf disable all

Example: (config-l2tpc-1)# ip ospf disable all

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf hello-interval

Use the L2TPC no ip ospf hello-intervalcommand to reset the interval of time to the default setting of the path cost to the default setting of 10 seconds. To define the interval of time between hello packets sent on the interface, see ip ospf hello-intervalcommand on page 15-8.

Syntax: (config-l2tpc-{n})# no ip ospf hello-interval

Example: (config-l2tpc-1)# no ip ospf hello-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 15-15