Carrier Access none manual Debug portmon serial, Port, Example adit 3500# debug portmon 1 rip

Privileged Mode

debug portmon serial

Use the debug portmon serial command allows the user to monitor traffic on a serial interface.

Note: Immediately after this command is issued, any traffic that falls into the filter parameter will be displayed. To turn the monitoring off, you must issue a no debug portmon command. See no debug portmon command on page 3-16.

Syntax: # debug portmon serial port {allarp addressbootp

addresscontroldatadns addressicmp addressip address linkmgcp addressrip addresssip addressstptcp {address address:portport}udp {addressaddress:portport}}

Field	Definition
port	Displays specific port traffic.
	Adit 3104: Value must be 1.
	Adit 3500: Range = 1-4.
	MSR: Range = 1-8.
all	Allows all traffic.
arp	Displays all Address Resolution Protocol traffic.
	address = IP address of the interface.
bootp	Displays BootP related traffic.
	address = IP address of the interface.
control	Displays control related traffic.
data	Displays data related traffic.
dns	Displays Domain Naming Service related traffic.
	address = IP address of the interface.
icmp	Displays Internet Control Message Protocol related traffic.
	address = IP address of the interface.
ip	Displays Internet Protocol related traffic Note: Requires an IP address.
	address = IP address of the interface.
link	Displays link related traffic.
mgcp	Displays Media Gateway Control Protocol related traffic.
	address = IP address of the interface.
rip	Displays Routing Information Protocol related traffic.
	address = IP address of the interface.
sip	Displays Session Initiation Protocol related traffic.
	address = IP address of the interface.
stp	Displays Spanning Tree Protocol related traffic.
tcp	Displays Transmission Control Protocol related traffic.
	address = IP address of the interface.
	address:port = IP address
	port = Port of the interface

Example: adit 3500# debug portmon 1 rip

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 3-11