Carrier Access none manual Syntax config-int-mlink-n# ip route-mode naptroute

Configuration - Multilink Interface Mode

ip route-mode

Use the Multilink Interface ip route-modecommand to configure the routing mode.

Syntax: (config-int-mlink-{n})# ip route-mode {naptroute}

Field

napt

route

Definition

Set to NAPT mode. Default.

NAPT is used if doing private IPs on the Ethernet side or if you want to hide specific publics on the internal side.

Set to Route mode. Routing is used if public is visible on both sides.

Example: (config-int-mlink-1)# ip route-mode napt

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip secondary-dns

Use the Multilink Interface ip secondary-dnscommand to configure the secondary DNS. To delete a secondary DNS address, see no ip secondary-dnscommand on page 12-18.

Syntax: (config-int-mlink-{n})# ip secondary-dns address

Field	Definition
address	Enter the IP address of the secondary Domain Name Server (DNS).

Example: (config-int-mlink-1)# ip secondary-dns 192.168.1.200

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

metric

Use the Multilink Interface metric command to configure the Metric of the IP network on this interface.

Syntax: (config-int-mlink-{n})# metric metric

Field	Definition
metric	Range is 0-255, with a default is 10.

Example: (config-int-mlink-1)# metric 150

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-13