Carrier Access none manual Adit 3000 Rel .6 and MSR Card Rel 2.0 CLI

Configuration - Serial Interface Mode

no ip ospf cost

Use the Serial Interface no ip ospf cost command to reset the cost path to the default setting of 0. To define the cost of sending a packet on this serial interface, see ip ospf cost command on page 13-8.

Syntax: (config-int-ser-{n})# no ip ospf cost

Example: (config-int-ser-1)# no ip ospf cost

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf dead-interval

Use the Serial Interface no ip ospf dead-intervalcommand to reset the interval of time to the default setting of 40 seconds. To define the interval of time that no hello packets have been seen before neighbors declare the router down, see ip ospf dead-intervalcommand on page 13-8.

Syntax: (config-int-ser-{n})# no ip ospf dead-interval

Example: (config-int-ser-1)# no ip ospf dead-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf disable

Use the Serial Interface no ip ospf disable command to enable OSPF processing on this interface. To disable OSPF on this interface, see ip ospf disable command on page 13-9.

Syntax: (config-int-ser-{n})# ip ospf disable all

Example: (config-int-ser-1)# ip ospf disable all

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf hello-interval

Use the Serial Interface no ip ospf hello-intervalcommand to reset the interval of time to the default setting of the path cost to the default setting of 10 seconds. To define the interval of time between hello packets that are sent on the interface, see ip ospf hello-intervalcommand on page 13-9.

Syntax: (config-int-ser-{n})# no ip ospf hello-interval

Example: (config-int-ser-1)# no ip ospf hello-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

13-16 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI