Carrier Access none manual Ppp authentication, Ppp encryption, Ppp exec-timeout

Configuration - Multilink Interface Mode

ppp authentication

Use the Multilink Interface ppp authentication command to configure the support of authentication types for the password. To disable PPP authentication, see no ppp authentication command on page 12-18.

Syntax: (config-int-mlink-{n})# ppp authentication {chapms-chapv1 ms-chapv2pap}

Field	Definition
chap	Support Challenge Handshake Authentication (CHAP)
ms-chapv1	Support Microsoft CHAP (MS-CHAP).
ms-chapv2	Support Microsoft CHAP Version 2 (MS-CHAPv2).
pap	Support an unencrypted password.

Example: (config-int-mlink-1)# ppp authentication chap

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ppp encryption

Use the Multilink Interface ppp encryption command to configure the PPP encryption. To disable PPP encryption, see no ppp encryption command on page 12-18.

Syntax: (config-int-mlink-{n})# ppp encryption {40-bit128-bit}

Field	Definition
40-bit	Support Encryption (40 bit keys)
128-bit	Support Maximum Strength Encryption (128 bit keys)

Example: (config-int-mlink-1)# ppp encryption 40-bit

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ppp exec-timeout

Use the Multilink Interface ppp exec-timeoutcommand to configure the PPP maximum idle time before hangup.

Syntax: (config-int-mlink-{n})# ppp exec-timeout minutes

Field	Definition
minutes	Range is 0 - 99999 minutes.

Example: (config-int-mlink-1)# ppp exec-timeout 150

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 12-21