Carrier Access none manual Example config-int-ser-1# ip address 192.168.2.100 mask

Configuration - Serial Interface Mode

ip address

Use the Serial Interface ip address command to configure the IP address for the serial interface. To remove an IP address, see no ip address command on page 13-15.

Syntax: (config-int-ser-{n})# ip address {address mask maskauto unnumbered} [secondary]

Field	Definition
address	Enter an IP address to assign to the port.
mask	Enter a subnet mask for the IP address.
auto	Uses IPCP to assign an IP address.
unnumbered	Treat this as an un-numbered interface, as per RFC 1812.
secondary	Optional parameter, defines the address to be a secondary IP address.

Example: (config-int-ser-1)# ip address 192.168.2.100 mask 255.255.255.0

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip default-route

Use the Serial Interface ip default-routecommand to enable the default route. To disable the default route, see no ip default-routecommand on page 13-15.

Syntax: (config-int-ser-{n})# ip default-route enable

Example: (config-int-ser-1)# ip default-route enable

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

ip mtu

Use the Serial Interface ip mtu command to set the Maximum Transmission Unit. Sets the largest packet size (bytes) the network will allow to transmit.

Syntax: (config-int-ser-{n})# ip mtu {sizeauto}

Field

size

auto

Definition

Allows the user to set the Maximum Transmission Unit (MTU). size = range of 576 to 1500 bytes.

Auto sets the MTU at 1500 bytes.

Example: (config-int-ser-1)# ip mtu auto

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

13-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI