Ovation Software Label Printer manual Loading Media for Peel Configuration

Getting Started

1.7 Loading Media for Peel Configuration

1. Open the cover.

2. Push the printhead latch toward the back of the printer and raise the printhead carrier assembly.

3. Place a roll of media (labels should be facing up) on the media hub and insert into the printer.

4. Pull the Peel-off Lever forward to the ‘open’ position.

5. Remove 6² (152 mm)of labels from the backing. Route the backing over the tearbar and behind the peel-off shaft as shown below.

Figure 1-6 Loading Media for Peel Configuration

6. Push the Peel-off Lever back to the ‘closed’ position

7. Close the printhead carrier assembly and press down until it locks into place.

8. Close the cover and press the ‘feed’ button two or three times to feed the media and ensure proper tracking. The labels will separate automatically as it is feed through the printer.

6 Ovation™2