Ovation Software Label Printer manual System-Level Commands concluded

Printing Labels

Char	Description		Format
m	Set metric flag, enter metric mode	All references set to metric until reset
n	Clear metric flag, return to inch mode
O	Form edge offset (start of print	Onnnn = 4 digits, in/100 or mm/10
	position)
o	Cycle cutter
P	Enter character dump mode
p	Controlled pause
Q	Clear all memory modules
q	Clear module	qx = Module I.D. (Uppercase)
r	Select reflective sensor	Used for "black-strip" media sensing,
		(e.g. continuous tags, butt-cut labels.
		Stripe must be printed on back side of
		media)
S	Slew (feed) speed	Sx x = A -C (1.0 to 2.0 ips)
s	Set up for one print buffer	Set for 1 dot buffer processing. Use for
		full length dot buffer processing.
T	Printhead dot pattern test label
t	Test RAM memory module	a bbbK module good
	(Must be in Test Mode)	bbb	= 256 or 512, for size of module
U	Label format field replacement
V	Software switch settings	Vn	n = 4-Label Present, 2-Internal
		Batch, 1-Cutter Enable
v	Firmware version information	Sends version string to host
W	Request memory module information	Wx	x = F-font, G-graphic, L-label
w	Test FLASH module memory	Takes about 90 seconds
x	Delete module file	xMFname M=Module I.D, F=file type
X	Set default module bank	Xa a - A = Memory Module A
Y	Output sensor values	Dumps sensor values status to RS-232
		port
y	Select font symbol set (optional	y S xx
	scalable fonts only)	y = ASCII (0x79)
		S = ASCII (0x54)
		xx = symbol selection
z	Pack module
Z	Print internal information and dot	Zx	x= Module I.D
	pattern

Table 2-3 System-Level Commands (concluded)

20 Ovation™2