Carrier Access none manual Syntax config-pptps# end Example config-pptps# end, End-ip-address

Configuration - PPTPS Mode

end

Use the end command to exit the current configuration mode, and must be used to mark the end of any configuration file. This command can be entered in any configuration mode with the same result.

Syntax: (config-pptps)# end

Example: (config-pptps)# end

#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

end-address

Use the PPTP Server end-addresscommand to set the PPTP remote host IP address range end.

Syntax: (config-pptps)# end-address end-ip-address

Field	Definition
end-ip-address	Enter the end IP address of the range.

Example: (config-pptps)# end-address 192.168.1.250

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

exit

Use the exit command to close your current connection if you are in the User mode, or Privileged mode. If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you to the next higher level (example: back to Privileged mode from Interface configuration mode).

Syntax: (config-pptps)# exit

Example: (config-pptps)# exit

(config)#

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 18-3