Carrier Access none manual No ip ospf priority, No ip ospf retransmit-interval, No ip primary-dns

Configuration - Ethernet Interface Mode

no ip ospf priority

Use the Ethernet Interface no ip ospf priority command to set the router priority to the default setting of priority 1. To set the router priority, which determines the designated router for this network, see ip ospf priority command on page 11-12.

Syntax: (config-int-eth-{n})# no ip ospf priority

Example: (config-int-eth-1)# no ip ospf priority

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf retransmit-interval

Use the Ethernet Interface ip ospf retransmit-intervalcommand to restore the default value of 5 seconds. To define the interval of time between link state advertisement retransmissions for adjacencies belonging to the interface, see ip ospf retransmit-intervalcommand on page 11-12.

Syntax: (config-int-eth-{n})# no ip ospf retransmit-interval

Example: (config-int-eth-1)# no ip ospf retransmit-interval

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf transmit-delay

Use the Ethernet Interface no ip ospf transmit-delaycommand to restore the default value of 1 second. To define the estimated time to transmit a link state update packet on the interface, see ip ospf transmit-delaycommand on page 11-12.

Syntax: (config-int-eth-{n})# no ip ospf transmit-delay

Example: (config-int-eth-1)# no ip ospf transmit-delay

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

no ip primary-dns

Use the Ethernet Interface no primary-dnscommand to disable the primary DNS. To set the DNS primary IP address, see ip primary-dnscommand on page 11-13.

Syntax: (config-int-eth-{n})# no ip primary-dns

Example: (config-int-eth-1)# no ip primary-dns

Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR

11-20 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI