Maintenance
uPay attention that the defrost water does not run into the kitch- en unit. *
uIf necessary, pick up defrost water several times, using a sponge or cloth.*
uClean the appliance (see 6.3) and rub dry.*
uWipe dry the appliance and items of equipment.
uConnect the appliance and switch it on again.
uSwitch on SuperFrost (see 5.8.4) .
When the temperature is sufficiently cold:
uPut the food back inside.
6.2 Defrosting with NoFrost*
The NoFrost system automatically defrosts the appliance.
Refrigerator compartment:
The defrost water evaporates due to the compressor heat.
u Regularly clean the drain opening to allow the water to flow away (see 6.3) .
Freezer compartment:
The moisture condenses on the evaporator, is periodically de- frosted and evaporates.
u The appliance does not have to be manually defrosted.
6.3 Cleaning the appliance.
Before cleaning:
CAUTION
Risk of injury and damage as a result of hot steam! Hot steam may damage the surfaces and cause burns. u Do not use any steam cleaners!
NOTICE
Incorrect cleaning damages the appliance!
u Do not use cleaning agents in concentrated form.
u Do not use any scouring or abrasive sponges or steel wool. u Do not use any cleaning agents containing sand, chloride,
chemicals or acid.
u Do not use chemical solvents.
u Do not damage or remove the type plate on the inside of the appliance. It is important for the customer service.
u Do not pull off, bend or damage cables or other components. u Do not allow any cleaning water to enter the drain channel,
ventilation grille or electrical parts.
u Empty the appliance. u Pull out the plug.
- Use soft cleaning cloths and a
- Only use food compatible cleaning and care agents on the inside of the appliance.
Outside surfaces and interior:
u Clean the plastic surfaces, outside and inside, by hand using lukewarm water and a little
u To clean the drain opening: remove any deposits with a fine instrument, e.g. a cotton bud.
Items of equipment:
u Clean butter dish in the dishwasher.
u Clean other items of equipment by hand with lukewarm water and a little
u For cleaning, remove the support rails for the
u To dismantle the shelves: remove the trims and side parts.
u To dismantle the storage rack: re- move the protective film from the dec- orative trims.
After cleaning:
6.4 Cleaning the IceMaker*
Fig. 32
The IceMaker has to be switched on.
u Pull out the drawer and remove the ice cubes.
u Clean the drawer with warm water and mild
(about 10 seconds).
w After about 1 s the LED goes out, the IceMaker is switched off. w After about 10 s the LED flashes for about 60 s.
u Slide in the drawer while the LED is flashing.
w The
u Clean the ice cube tray with warm water. If necessary, use mild
Switch the IceMaker on again.
u Press the ON/OFF button until the LED shines, then slide in the drawer.
w The IceMaker starts producing ice cubes. If
u throw away the first three loads of ice cubes to get rid of any remaining
6.5 Customer service
First check whether you can correct the fault yourself by refer- ence to the list (see Malfunction). If this is not the case, please contact the customer service whose address is given in the en- closed customer service list.
WARNING
Risk of injury if repair work is not carried out professionally!
u Have any repairs to and intervention in the appliance and mains power cable, which are not expressly mentioned in the (see Maintenance) carried out by the customer service only.
u Read the appliance designation Fig. 33 (1), service No. Fig. 33 (2)
and serial No. Fig. 33 (3) off the type plate located inside the appliance on the left- hand side.
Fig. 33 u Notify the customer service, specifying the fault, appliance designation Fig. 33 (1), service No. Fig. 33 (2) and serial No.
Fig. 33 (3).
w This will help us to provide you with a faster and more accurate service.
u Keep the appliance closed until the customer service arrives. w The food will stay cool longer.
16
