4.3.1 Installing the appliance
Fig. 8
uDetach the connecting cable from the rear of the appli-
ance. Remove the cable holder otherwise there will be
vibratory noise.
uLay the connecting cable with
the help of string in such a way
that the appliance can be easily
connected following installation.
Fig. 9
For appliances with permanently plumbed in IceMaker:
uConnect the IceMaker (see 4.2) .
All appliances:
uSlide the appliance 3/4 of the way into the recess.
uRemove the covers
Fig. 8 (5,6,7)
.
uFit the equaliser trim
Fig. 10 (20)
concentrically
onto the appliance: Slide it
into the recess and engage
it in the keyholes.
Fig. 10
uScrew all the mounting
brackets
Fig. 11 (34)
to the
pre-drilled holes in the ap-
pliance door using hexa-
gon screws
Fig. 11 (35)
.
Fig. 11
For 16 mm-thick unit walls =
568 mm-wide recess:
uClip spacer
Fig. 12 (23)
onto the
upper hinge and spacer
Fig. 8 (24)
onto the lower hinge.
Fig. 12
uAttach the top cover
Fig. 13 (53)
and bottom cov-
er
Fig. 13 (50)
to the mount-
ing brackets.
uFasten the mounting brack-
ets
Fig. 13 (50)
at the top and
bottom with screws
Fig. 13 (51)
so that the brack-
ets can still be moved a little
to the left and right.
Fig. 13
uStrip the protective film off the cover trim
Fig. 14 (22)
. Apply the cover trim
Fig. 14 (22)
to the projection of the cover
Fig. 13 (53)
on the handle side, flush with the
front, and adhesively affix it to the side wall
of the appliance.
uIf necessary, shorten the cover strip
Fig. 14 (22)
at the bottom: The cover strip
Fig. 14 (22)
has to end 3 mm above the up-
per edge of the lower mounting bracket
Fig. 8 (50)
.
Fig. 14
Slide in and align the appliance:
uSlide in the appliance until the covers
Fig. 13 (53)
abut
Fig. 13
against the side wall of the kitchen unit.
uExtend the adjustable foot.
For 16 mm-thick unit walls =
568 mm-wide recess:
uAllow the spacers to abut
against the side wall of the kitch-
en unit.
Fig. 15
For 19 mm-thick unit walls =
562 mm-wide recess:
uAlign the front edges of the hing-
es so as to be flush with the side
wall of the kitchen unit.
Fig. 16
For kitchen units (16 mm and 19 mm) with door stop
components (knobs, sealing lips etc.):
uAllow for the extra distance (depth of the door stop compo-
nents): Allow hinges and covers
Fig. 13 (53)
to protrude by the
extra distance.
All appliances:
Putting into operation
7