Viewing Automatically Configured IP Information | 43 |
■A suitable cable:
■A standard null modem cable — if you are connecting directly to the console port, or
■A standard modem cable — if you are connecting to the console port using a modem.
You can find
■A Category 5 twisted pair Ethernet cable with
Connecting the Workstation to the Switch
1Connect the workstation to the console port using a standard null modem cable as shown in Figure 13.
Figure 13 Connecting a workstation to the Switch via the console port
To connect the cable:
aAttach the female connector on the cable to the male connector on the console port of the Switch.
bTighten the retaining screws on the cable to prevent it from being loosened.
cConnect the other end of the cable to one of the serial ports (also known as a COM port) on your workstation.
2Open your terminal emulation software and configure the COM port settings to which you have connected the cable. The settings should be set to match the default settings for the Switch, which are:
■19,200 baud
■8 data bits
■no parity
■1 stop bit
■no hardware flow control
Refer to the documentation that accompanies the terminal emulation software for more information.
