Brocade Communications Systems 53-1001761-01 manual Switchconfig#interface tengigabitethernet 0/0

3 Minimum CEE configuration to allow FCoE traffic flow

To set the minimum CEE configuration, perform the following steps in global configuration mode.

1.Configure the CEE interface as a Layer 2 switch port. For details, see “Configuring an interface port as a Layer 2 switch port” on page 36.

Example of configuring the switch port as a 10-Gigabit Ethernet interface.

switch(config)#interface tengigabitethernet 0/0

switch(config-if)#switchportswitch(config-if)#no shutdown switch(config-if)#exit

switch(config)#end

2.Create a CEE Map to carry LAN and SAN traffic and apply it to an interface. For details, see “Converged Enhanced Ethernet map configuration” on page 106.

Example of creating a CEE map for 10-Gigabit Ethernet interface.

switch(config)#cee-map default switch(conf-cee-map)#priority-group-table 1 weight 40 pfc switch(conf-cee-map)#priority-group-table 2 weight 60 switch(conf-cee-map)#priority-table 2 2 2 1 2 2 2 2 switch(conf-cee-map)#interface tengigabitethernet 0/2 switch(conf-if-te-0/2)#cee default switch(conf-if-te-0/2)#exit

3.Create an FCoE VLAN and add an interface to it. For details, see “Configuring an interface port as an access interface” on page 36.

Example of creating a FCoE VLAN and adding a single interface.

switch(config)#vlan classifier rule 1 proto fcoe encap ethv2 switch(config)#vlan classifier rule 2 proto fip encap ethv2 switch(config)#vlan classifier group 1 add rule 1 switch(config)#vlan classifier group 1 add rule 2 switch(config)#interface vlan 1002 switch(conf-if-vl-1002 )#fcf forward switch(conf-if-vl-1002 )#interface tengigabitethernet 0/0 switch(config-if-te-0/0)#switchport switch(config-if-te-0/0)#switchport mode converged switch(config-if-te-0/0)#switchport converged allowed vlan add 1002 switch(config-if-te-0/0)#vlan classifier activate group 1 vlan 1002 switch(config-if-te-0/0)#cee default switch(config-if-te-0/0)#no shutdown switch(config-if-te-0/0)#exit

4.Configure LLDP for FCoE. For details, see “Configuring LLDP interface-level command options” on page 83.

Example of configuring LLDP for 10-Gigabit Ethernet interface.

switch(config)#protocol lldp

switch(conf-lldp)#advertise dcbx-fcoe-app-tlv switch(conf-lldp)#advertise dcbx-fcoe-logical-link-tlv

5. Enter the copy command to save the running-configfile to the startup-configfile.

switch(conf-lldp)#exit

switch(config)#end

switch#copy running-config startup-config

30	Converged Enhanced Ethernet Administrator’s Guide
	53-1001761-01