Brocade Communications Systems 53-1001761-01 manual Example of setting the map name to srvgroup

3 CEE and LAN integration

To configure the CEE interfaces, perform the following steps in global configuration mode. 1. Assign VLANs to the uplink Ethernet port.

NOTE

You must repeat this step for all uplink interfaces. For details, see “Configuring an interface port as a trunk interface” on page 37.

Example of assigning VLAN 10 and VLAN 20 to the uplink Ethernet port.

switch(config)#interface TenGigabitEthernet 0/1 switch(conf-if-te-0/1)#switchport switch(conf-if-te-0/1)#switchport mode trunk switch(conf-if-te-0/1)#switchport trunk allowed vlan add 10 switch(conf-if-te-0/1)#switchport trunk allowed vlan add 20 switch(conf-if-te-0/1)#no shutdown

2.Apply the VLAN classifier group to the interfaces. For details, see “Activating a VLAN classifier group with an interface port” on page 40.

Example of applying a VLAN classifier group 1 to the interfaces.

switch(config)#interface TenGigabitEthernet 0/10 switch(conf-if-te-0/1)#switchport switch(conf-if-te-0/1)#switchport mode access switch(conf-if-te-0/1)#switchport access vlan 10 switch(conf-if-te-0/1)#vlan classifier activate group 1 vlan 100 switch(conf-if-te-0/1)#no shutdown

3.Apply the CEE map to the interfaces. For details, see “Applying a CEE provisioning map to an interface” on page 110.

Example of setting the map name to srvgroup.

switch(conf-if-te-0/1)#cee srvgroup

4. Enter the copy command to save the running-configfile to the startup-configfile.

switch(conf-if-te-0/1)#exit

switch(config)#end

switch#copy running-config startup-config

28	Converged Enhanced Ethernet Administrator’s Guide
	53-1001761-01