Brocade Communications Systems 53-1001761-01 manual Disabling spanning tree

Configuring STP, RSTP, or MSTP on CEE interface ports 5

To enable spanning tree on the CEE interface, perform the following steps from Privileged EXEC mode.

1.Enter the configure terminal command to access global configuration mode.

2.Enter the interface command to specify the CEE interface type and slot/port number.

switch(config)#interface tengigabitethernet 0/1

3.Enter the no shutdown command to enable the CEE interface.

4.Enter the spanning-treecommand to enable spanning tree on the CEE interface.

switch(conf-if-te-0/1)#no spanning-tree shutdown

Disabling spanning tree

From the CEE interface, use this command to disable spanning tree on the CEE interface. By default, spanning tree is disabled.

To enable spanning tree on the CEE interface, perform the following steps from Privileged EXEC mode.

1.Enter the configure terminal command to access global configuration mode.

2.Enter the interface command to specify the CEE interface type and slot/port number.

switch(config)#interface tengigabitethernet 0/1

3.Enter the no shutdown command to enable the CEE interface.

4.Enter the spanning-treecommand to enable spanning tree on the CEE interface.

switch(conf-if-te-0/1)#spanning-tree shutdown

Converged Enhanced Ethernet Administrator’s Guide	63
53-1001761-01