Brocade Communications Systems 53-1001761-01 manual Interface port-channel

2 CEE Command Line Interface

NOTE

At system startup, if you try to enter Privileged EXEC mode before the system has fully booted, the following message is displayed:

%Info: Please wait. System configuration is being loaded.

After the system has fully booted, a RASLOG message indicates that the CEE CLI is ready to accept configuration commands.

TABLE 3	CEE CLI command modes
Command	Prompt	How to access the command mode	Description
mode
EXEC	switch>	Enter the cmsh command at the	Display running system information
		Fabric OS prompt after you have	and set terminal line parameters.
		logged in as an appropriate user.

Privileged	switch#	From the EXEC mode, enter the
EXEC		enable command.

Display and change system parameters. Note that this is the administrative mode and also includes EXEC mode commands.

Global	switch(config)#	From the EXEC mode, enter the		Configure features that affect the
configuration		configure terminal EXEC command.		entire switch.
Interface	Port-channel:	From the global configuration mode,		Access and configure individual
configuration	switch(conf-if-po-63)#	specify an interface by entering one		interfaces.
		of the following interface types:
	10-Gigabit Ethernet (CEE port):	•	interface port-channel
	switch(conf-if-te-0/1)#	•	interface tengigabitethernet
		•	interface vlan

VLAN: switch(conf-if-vl-1)#

Protocol LLDP: configuration switch(conf-lldp)#

Spanning-tree: switch(conf-mstp)# switch(conf-rstp)# switch(conf-stp)#

From the global configuration mode, Access and configure protocols. specify a protocol by entering one of

the following protocol types:

•protocol lldp

•protocol spanning-tree mstp

•protocol spanning-tree rstp

•protocol spanning-tree stp

16	Converged Enhanced Ethernet Administrator’s Guide
	53-1001761-01