Brocade Communications Systems 53-1001761-01 manual 802.1x authentication configuration tasks

10 802.1x authentication configuration tasks

802.1x authentication configuration tasks

The tasks in this section describe the common 802.1x operations that you will need to perform. For a complete description of all the available 802.1x CLI commands for the Brocade FCoE hardware, see the Converged Enhanced Ethernet Command Reference.

Configure authentication

between the switch and CNA or NIC

For complete information on the aaaConfig command, see the Fabric OS Command Reference and the Fabric OS Administrator’s Guide.

NOTE

The aaaConfig command attempts to connect to the first RADIUS server. If the RADIUS server is not reachable, the next RADIUS server is contacted. However, if the RADIUS server is contacted and the authentication fails, the authentication process does not check for the next server in the sequence.

Perform the following steps to configure authentication.

1.Connect to the switch and log in using an account assigned to the admin role.

2.Add the RADIUS to the switch as the authentication server. This FOS CLI command moves the new RADIUS server to the top of the access list.

switch:admin> aaaconfig --add 10.2.2.147 -conf radius 1

3. Enter global configuration mode.

switch:admin>cmsh

switch#configure t

4. Enable 802.1x authentication globally

switch(config)#dot1x enable

5. Enter the copy command to save the running-configfile to the startup-configfile.

switch(config)#end

switch#copy running-config startup-config

Interface-specific administrative tasks for 802.1x

It is essential to configure the 802.1x port authentication protocol globally on the Brocade FCoE hardware, and then enable 802.1x and make customized changes for each interface port. Since 802.1x was enabled and configured in “802.1x authentication configuration tasks”, use the administrative tasks in this section to make any necessary customizations to specific interface port settings.

Configuring 802.1x on specific interface ports

To configure 802.1x port authentication on a specific interface port, perform the following steps from Privileged EXEC mode. Repeat this task for each interface port you wish to modify.

1. Enter the configure terminal command to access global configuration mode.

112	Converged Enhanced Ethernet Administrator’s Guide
	53-1001761-01