xx Converged Enhanced Ethernet Administrator’s Guide
53-1001761-01
DRAFT: BROCADE CONFIDENTIAL
1. General Information
•Switch model
•Switch operating system version
•Software name and software version, if applicable
•Error numbers and messages received
•supportSave command output
•Detailed description of the problem, including the switch or fabric behavior immediately
following the problem, and specific questions
•Description of any troubleshooting steps already performed and the results
•Serial console and Telnet session logs
•syslog message logs
2. Switch Serial Number
The switch serial number and corresponding bar code are provided on the serial number label,
as illustrated below:
The serial number label is located as follows:
•Brocade 300, 4100, 4900, 5100, 5300, 7500, 7800, 8000, VA-40FC, and Brocade
Encryption Switch—On the switch ID pull-out tab located inside the chassis on the port side
on the left
•Brocade 5000—On the switch ID pull-out tab located on the bottom of the port side of the
switch
•Brocade 7600—On the bottom of the chassis
•Brocade 48000—Inside the chassis next to the power supply bays
•Brocade DCX—On the bottom right on the port side of the chassis
•Brocade DCX-4S—On the bottom right on the port side of the chassis, directly above the
cable management comb
3. World Wide Name (WWN)
Use the licenseIdShow command to display the WWN of the chassis.
If you cannot use the licenseIdShow command because the switch is inoperable, you can get
the WWN from the same place as the serial number, except for the Brocade DCX. For the
Brocade DCX, access the numbers on the WWN cards by removing the Brocade logo plate at
the top of the nonport side of the chassis.
Document feedback
Quality is our first concern at Brocade and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
*FT00X0054E9*
FT00X0054E9