TIMER
SETTING THE SLEEP TIMER
GENERAL
CARE AND MAINTENANCE
MULTI JOG
SLEEP
Occasional care and maintenance of the unit is needed to |
|
optimize the performance of your unit. | TIMER GENERAL |
To clean the cabinet | |
Use a soft dry cloth. | |
If the surfaces are extremely dirty, use a soft cloth lightly | |
|
JOG
SHIFT
The unit can be automatically turned off at a specified time.
1 Hold down SHIFT and press SLEEP on the remote control.
" " is displayed.
2 Within 6 seconds, press JOG +or
With each press, the timer duration changes in
The unit turns off after the selected time.
• MULTI JOG on the unit is also available.
To check the remaining time until the unit turns off
Hold down SHIFT and press SLEEP on the remote control. The remaining time is displayed for 6 seconds.
To cancel the sleep timer
Hold down SHIFT and press SLEEP on the remote control repeatedly so that " , " is displayed.
moistened with mild detergent solution. Do not use strong |
solvents, such as alcohol, benzine or thinner as these could |
damage the finish of the unit. |
TROUBLESHOOTING GUIDE
If the unit fails to perform as described in these Operating Instructions, check the following guide.
GENERAL
There is no sound.
•Is the AC cord connected properly?
•Is there an incorrect connection? (➞ pages
•There may be a short circuit in the speaker terminals.
➞Disconnect the AC cord, then correct the speaker connections.
•Was an incorrect function selected?
•Is FRONT SPEAKERS A or B set correctly? (➞ page 9)
Sound is emitted from one speaker only.
•Is BALANCE set appropriately?
•Is the other speaker disconnected?
Sound is heard at a very low volume. | En | |
• Has MUTING been pressed? | ||
| ||
An erroneous display or a malfunction occurs. |
| |
| ||
➞ Reset the unit as stated below. |
| |
TUNER SECTION |
|
There is constant,
• Is the antenna connected properly? (➞ page 7)
• Is the FM signal weak?
➞ Connect an outdoor antenna.
The reception contains noise interference or the sound is distorted.
•Is the system picking up external noise or multipath distortion?
➞Change the orientation of the antenna.
➞Move the unit away from other electrical appliances.
To reset
If an unusual condition in the display window or malfunction occurs, reset the unit as follows:
1Press POWER 6STANDBY/ON to turn off the power.
2Press POWER 6STANDBY/ON while pressing ENTER. Everything stored in memory after purchase is cancelled.
If the power cannot be turned off in step 1 because of a malfunction, disconnect the AC cord, and reconnect the AC cord after several seconds. Then carry out step 2.
ENGLISH 19
