OTHER SETTINGS
ENTER
MIDNIGHT
MULTI JOG
MANUAL
SELECT
JOG
SHIFT
ADJUSTING LOW FREQUENCY SOUND EFFECT (LFE)
The disc recorded in Dolby Digital surround contains special signals called LFE to enhance low frequency sound effect. The LFE signals are recorded in some particular parts on the disc and output from the connected sub woofer to reproduce astonishingly powerful low sound.
The sound level of the LFE signals can be adjusted according to your speakers.
Preparation
Play a disc recorded in Dolby Digital surround.
1 Press MANUAL SELECT on the remote control.
"" is displayed.
2 Press JOG +or -to adjust the LFE level.
The unit is initially set to 0 dB (maximum) and can be adjusted as follows:
OFF
MULTI JOG on the unit is also available.
When selecting " ", the LFE signals are redistributed to other speakers.
ADJUSTING DYNAMIC RANGE
Dynamic range of the sound can be adjusted. The unit is initially set to " " (standard) mode.
Preparation
Play a disc recorded in Dolby Digital surround.
1 Hold down ENTER (hold down SHIFT and press MIDNIGHT).
" " runs through on the display.
2Turn MULTI JOG (press JOG + or
: You can enjoy the full dynamic range of sound like in the movie theatre.
: Original position, when playing back in home, that is recommended by the software producers.
+ : Select this mode when playing back at low volume.
TO LISTEN TO THE ORIGINAL DTS SOUND
When "!"" appears on the display, all the sound settings can be cancelled.
Preparation
Play a disc recorded in DTS surround.
1 Press ENTER.
" " is displayed.
2Press ENTER again so that " " is displayed.
To restore the sound settings
Repeat steps 1 and 2 so that " " appears.
To operate with the remote control
Hold down SHIFT and press MIDNIGHT repeatedly.
ADJUSTING THE SOUND OF DOLBY PRO LOGIC II MUSIC MODE
In Dolby Pro Logic II Music mode, press MANUAL SELECT repeatedly to select one of the adjusting modes (PANO, DMSN or CTR W). Then press JOG +or
Panorama mode (PANO): Expands stereo effect of the front speakers toward the rear sound field and enhances "surrounded" stereo effect.
Dimension mode (DMSN): Adjusts the level to move the broad sound field to the front side (F) or rear side (R). The level changes as follows:
R+3 R+2 R+1 OFF(normal) F+1 F+2 F+3
Centre width mode (CTR W): Redistributes centre speaker's signals to the front speakers.