Fisher & Paykel GC36, GC912M manuel dutilisation Auto re-ignition, Constant sparking, Power failure

Auto re-ignition

Auto Re-ignition is for your convenience and safety. The auto re-ignition feature causes the igniters to spark automatically if a flame blows out or if the flame is severely distorted by a draft or a cooktop ventilation system.

US

Constant sparking

The igniters must be kept clean and dry to work correctly. Dirty or wet igniters could cause constant sparking, even if a flame is present. (See trouble shooting guide).

Igniters can be kept clean with a small brush.

If the burner has inconsistent flame or does not light

If the gas does not ignite within four seconds, turn the knob to Off. Allow at least two minutes for the gas to disperse before trying again.

Check that the power to the product is switched on.

Check that the burner parts are assembled correctly as below:

Correct Assembly Incorrect Assembly

Power failure

In the event of a power failure, turn all burner control knobs to Off. The burners can be lit by holding a lighted match close to the side of the burner and turning the control knob to Hi. Wait until the flame is burning all the way around the burner cap before adjusting.

7