JVC CA-MXG950V manual Dubbing Tapes, CD Direct Recording, On the unit only Press Tape 2 3, then

Put a recordable cassette into deck B. Load CDs.

Continued

English

To record on both sides — Reverse Mode

Press REVERSE MODE so that the Reverse

Mode indicator lights up — .

•When using Reverse Mode for recording, start recording in the forward (3) direction

first. Otherwise, recording will stop when recording is done only on one side (reverse) of the tape.

To cancel Reverse Mode, press the button again so that the

Reverse Mode indicator lights up — .

Dubbing Tapes

You can record from one tape to another.

On the unit ONLY:

1 Press TAPE 2 3, then 7.

CD Direct Recording

Everything on the CD goes onto the tape in the orderlayed out on the CD.

On the unit ONLY:

1

2

3 Press one of the disc number buttons (CD1, CD2 and CD3) to select the disc, then 7.

4 Press CD REC START.

“CD REC” appears, and the (recording) indicator lights up on the

display.

Deck B starts recording and the CD player starts playing. When the recording is done, “CD REC FINISHED” appears on the display and deck B stop. CD player will continue play for the next tray until you press STOP button.

2 Put the source cassette into deck A, and a recordable cassette into deck B.

•Put the cassettes in both decks so that the tapes will run in the forward (3) direction.

3 Press DUBBING.

The (recording) indicator lights up on the display and dubbing starts.

To stop dubbing, press 7 so that both decks (A and B) stop.

To stop recording, press REC START/STOP or 7. So that a 4-second blank portion is created on the recording tape. (Remember a 4-second blank is important when using Music Scan — see page 23.)

•You cannot use CD Direct Recording to record a Program Play.

•Before recording on a tape, wind the tape on past the leader tape (about the first 3 or 4 seconds of each side).

To record on both sides — Reverse Mode

Press REVERSE MODE so that the Reverse

Mode indicator lights up — .

To cancel Reverse Mode, press the button again so that the Reverse Mode indicator

lights up — .

To record on both sides — Reverse Mode

Press REVERSE MODE so that the Reverse

Mode indicator lights up like — .

•When using the Reverse Mode for CD Direct Recording, start recording in the forward (3) direction first. When the tape reaches its end while recording a song in the forward direction (3), the last song will be re-recorded at the beginning of the reverse side (2).

If you start recording on the reverse side (2), recording will stop when recording is done only on one side (reverse) of the tape.

To cancel Reverse Mode, press the button again so that the

Reverse Mode indicator lights up — .

– 25 –