JVC CA-MXG950V manual Common Operations, Turning On or Off the Power, Setting the Clock

English

Common Operations

Turning On or Off the Power

To turn on the unit, press

STANDBY/ON so that the STANDBY lamp goes off.

To turn off the unit (on standby), press

STANDBY/ON again so that the

STANDBY lamp lights up.

•A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC

power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 13) will be erased in a few days.

To check the clock time

Press and hold SET/DISPLAY while playing any source.

•Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until the clock setting mode is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

Cancelled Clock ON TIME setting

(The hour digits start flashing.)

When you unplug the AC power cord or if a power failure occurs

The clock loses the setting and is reset to “0:00.” You need to set the clock again.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

Setting the Clock

Before operating the unit any further, first set the built in clock. You can set the clock whether the unit is on or off.

On the unit ONLY:

1 Press CLOCK/TIMER.

The hour digits start flashing on the display.

2 Turn 4/¢ to adjust the hour, then press SET/

DISPLAY.

The minute digits start flashing on the display.

• If you want to correct the hour after pressing SET/DISPLAY, press CANCEL/DEMO.

The hour digits start flashing again.

3 Turn 4/¢ to adjust the minute, then press SET/DISPLAY.

On the unit ONLY:

You can only change the AM tuner interval spacing while tuning into an AM station. (See page 13.)

Press STANDBY/ON while holding down 7.

• Each time you press these buttons, the AM tuner interval spacing alternates between

9 kHz and 10 kHz.

Selecting the Sources

To listen to the FM/AM broadcasts, press FM/AM.

(See page 13.)

To playback CDs, press CD 3¥8 SELECT. (See pages 14 – 17.)

To playback tapes, press TAPE 2 3. (See page 23.)

To select the external equipment as the source, press AUX.

When you press the play button for a particular source (FM/AM, CD 3/8 SELECT, TAPE 2 3 and AUX), the unit turns on (and the unit starts playing the source if it is ready —

COMPU PLAY CONTROL).

About the audio level indicator

All the audio level indicators light up when no signals come in.

– 10 –