Agilent Technologies 5203 manual Transceiver Jitter Performance, Recommended Handling Precautions

6

TRANSCEIVER RELATIVE OPTICAL POWER BUDGET AT CONSTANT BER (dB)

2.5

2.0

1.5

1.0

0.5

0

0.5

0 25 50 75 100 125 150 175 200

SIGNAL RATE (MBd)

CONDITIONS:

1.PRBS 27-1

2.DATA SAMPLED AT CENTER OF DATA SYMBOL.

3.BER = 10-6

4.TA = 25° C

5.VCC = 5 Vdc

6.INPUT OPTICAL RISE/FALL TIMES = 1.0/2.1 ns.

	1 x 10-2
RATE	1 x 10-3
	1 x 10-4
			HFBR-5203/5204/5205
ERROR	1 x 10-5				SERIES
	1 x 10-6
				CEN				YMBOL
BIT	1 x 10-7					TER OF S
	1 x 10-8
	1 x 10-9
	1 x 10-10
	1 x 10-11
	1 x 10-12
	-6	-4	-2	0			2		4
		RELATIVE INPUT OPTICAL POWER – dB

CONDITIONS:

1.155 MBd

2.PRBS 27-1

3.CENTER OF SYMBOL SAMPLING.

4.TA = 25° C

5.VCC = 5 Vdc

6.INPUT OPTICAL RISE/FALL TIMES = 1.0/2.1 ns.

Figure 5. Transceiver Relative Optical Power Budget at Constant BER vs. Signaling Rate.

Figure 6. Bit Error Rate vs. Relative Receiver Input Optical Power.

illustrates the typical trade-off between link BER and the receivers input optical power level.

Transceiver Jitter

Performance

The Agilent 1300 nm transceivers are designed to operate per the system jitter allocations stated in Table B1 of Annex B of the draft ANSI T1E1.2 Revision 3 standard.

The Agilent 1300 nm transmitters will tolerate the worst case input electrical jitter allowed in Annex B without violating the worst case output optical jitter requirements.

The Agilent 1300 nm receivers will tolerate the worst case input optical jitter allowed in Annex B without violating the worst case output electrical jitter allowed.

The jitter specifications stated in the following 1300 nm transceiver specification tables are derived from the values in Table B1 of Annex B. They represent the worst case jitter contribution that the transceivers are allowed to make to the overall system jitter without violating the Annex B allocation example. In practice, the typical contribution of the Agilent transceivers is well below these maximum allowed amounts.

Recommended Handling Precautions

Agilent recommends that normal static precautions be taken in the handling and assembly of these transceivers to prevent damage which may be induced by electrostatic discharge (ESD). The HFBR-5200 series of transceivers meet MIL-STD-883C Method 3015.4 Class 2 products.

Care should be used to avoid shorting the receiver data or signal detect outputs directly to ground without proper current limiting impedance.

Solder and Wash Process Compatibility

The transceivers are delivered with protective process plugs inserted into the duplex SC or duplex ST connector receptacle. This process plug protects the optical subassemblies during wave solder and aqueous wash processing and acts as a dust cover during shipping.

These transceivers are compatible with either industry standard wave or hand solder processes.

Shipping Container

The transceiver is packaged in a shipping container designed to