Weider 160xtb user manual Problem Television reception is poor

Page 28
b Battery Cover

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: Television reception is poor

SOLUTION: a. Check for the problems listed below and follow the applicable instructions.

Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)—Usually this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or other electric appliances. Try changing the position of other electric appliances to correct the problem. Make sure that the treadmill is plugged into its own electrical circuit.

Ghosts—Ghosts are caused by the television signal following two paths—one is the direct path and the other is reflected from tall buildings, hills, or other objects.

Blue Screen—If the cable channel signal is weak, the picture may be of poor quality or a blue screen may appear.

Note: If one of these symptoms appears, the symptom may be caused by the local cable com- pany signal reception. Contact the local cable company.

PROBLEM: The chest pulse sensor does not function properly

SOLUTION: a. If the chest pulse sensor does not function properly, see CHEST PULSE SENSOR TROU- BLESHOOTING on page 12.

b. If the chest pulse sensor still does not function properly, the battery should be changed. To replace the battery, locate the battery cover on the back of the sensor unit. Insert a coin into the slot in the cover and turn the cover counterclockwise to the “open” position. Remove the cover.

Remove the old battery from the sensor unit. Insert a new CR 2032 battery, making sure that the writing is on top. In addition, make sure that the rubber gasket is in place in the sensor unit. Replace the bat- tery cover and turn it to the closed position.

Battery

Cover

Battery

Rubber

Gasket

28

Image 28
Contents QUESTIONS? Model No. WBTL14608.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Page Power Lines Service Before YOU Begin Assembly Not tighten the Upright Bolts yet Ful not to pinch the Upright Wire HarnessUpright Bolts yet Make sure that no wires are pinched Page HOW to Connect a 75 OHM Catv Cable HOW to Connect AN External Source Using a Catv CableHOW to USE the Chest Pulse Sensor Chest Pulse Sensor Care and MaintenanceHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired Turn on the fan if desiredSelect an event training program HOW to USE AN Event Training ProgramPress the Start button to start the program Select a preset program HOW to USE a Preset ProgramEnter your weight HOW to Create a Custom Program Select one of the four custom programsHOW to USE a Custom Program Follow the steps below to use a heart rate program HOW to USE the Stereo Sound System Press the TV button again and add or delete cable channels HOW to USE the Information ModePress the TV button again and select a cable connection HOW to Adjust the Cushioning System HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useProblem Solution ProblemProblem Television reception is poor Problem The chest pulse sensor does not function properlyExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. WBTL14608.0 Key No. Qty DescriptionDescription Key No. Qty Exploded DRAWING-Model No. WBTL14608.0 124 114 126 125 122 120 110 121 116 7590 123 109 102 112 111 Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT