Weider 831.153921 user manual

9.Attach two 8mm Metal Spacers (91), a 60mm Metal Spacer (39), and two Bearing Wheels (46) to one end of the Seat Carriage (12) with an M8 x 104mm Button Head Bolt (60) and an M8 Nylon Locknut (65) as shown. Make sure that the parts are oriented as shown in the inset drawing; the Seat Knob (not shown) will not engage the Bench Rail (not shown) if they are incorrectly oriented. Do not overtighten the Locknut; the Bearing Wheels must be able to roll easily.

Attach two Bearing Wheels (not shown) to the other end of the Seat Carriage (12) in the same manner.

10.Attach the Seat Knob (45) to the Seat Carriage (12) with two M6 x 13mm Bolts (92) and two M6 Nylon Locknuts (69). Make sure that the slot in the Knob is aligned with the slot in the Seat Carriage, as shown.

Orient the Seat (13) and the Seat Carriage (12) as shown. Attach the Seat to the Seat Carriage with four 1/4” x 16mm Screws (82).

11.Pull out the Seat Knob (45) as far as it will go, and set the Seat Carriage (12) on the Bench Rail (5).

Loosely attach two 8mm Metal Spacers (91), a 60mm Metal Spacer (39), and two Bearing Wheels (46) to the center holes in the Seat Carriage (12) with two M8 Flange Nuts (19) and the M8 x 114mm Axle (57). Make sure that the serrated edge of the Flange Nuts are against the Seat Carriage.

While a second person presses down on the Seat (13), hold the wheel assembly firmly against the bottom of the Bench Rail (5) and properly tighten the M8 Flange Nuts (19). Make sure that three threads are extending past the Nut, and that the wide sides of all six Wheels (46) are pressed against the Bench Rail.

Engage the Seat Knob (45) into an adjustment hole in the Bench Rail (5).

9		12
60
		Attach second
		set of wheels
		here
	65
91
46
39	91
46
		46
	91	39		46
				91
	Wide
	Side
10
13
12		Slots
		92
	69	45
		92
	82
82
11
19	13
57		5
	19
12
45
	39
91	Adjustment Hole
46
	91
		46
	91	39	46
				91
	Wide
	Side

8