3.Be sure that the Uprights (1) are oriented as shown. The high side of the weight rests must be on the side indicated. Attach the Frame (2) to the Crossbar (3) with two M8 x 57mm Bolts (14), two M8 Washers (12) and two M8 Nylon Locknuts (13).
4.Tap a 30mm Square Inner Cap (22) into each end of the Leg Lever (4).
Tap a 1” Round Inner Cap (24) into the indicated end of the weight tube. Tap the 1” Angled Round Cap (20) onto the other end of the weight tube.
5.Lubricate the M10 x 63.5mm Bolt (18). Attach the Leg Lever (4) to the Frame (2) with the Bolt, the M10 Washer (25), and the M10 Nylon Locknut (19).
6.Tap two 3/4” Round Inner Caps (9) into each Pad Tube (10). Insert the Pad Tubes into the holes in the Leg Lever (4). Slide two Foam Pads (23) onto each Pad Tube.
3 |
|
| High Side of |
|
|
| Weight Rests |
| 1 |
|
|
|
| 1 |
|
| 12 | 13 |
|
|
|
| |
14 |
|
| 12 |
2 |
| 3 |
|
| 14 |
| |
|
|
| |
4 |
|
|
|
22 |
|
| 4 |
|
|
| |
|
|
| 20 |
24 |
|
|
|
|
|
| 22 |
5 |
| ||
|
|
| 2 |
4 |
|
| 19 |
| 25 |
| |
|
|
| |
6 |
|
|
|
23 |
|
|
|
| 4 |
|
|
|
| 9 | 10 |
|
|
| |
|
|
| 9 |
|
|
| 23 |
7