Weider 831.150280 user manual Following Tools not Included are Required for Assembly

Assembly

Before beginning assembly, carefully read the following information and instructions:

•Place all parts of the WEIDER® 128 in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

•Read each assembly step before you begin.

•As you assemble the WEIDER® 128, make sure that all parts are oriented as shown in the draw- ings.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

•Two (2) adjustable wrenches

•One (1) phillips screwdriver

•For help identifying the small parts used in assembly, use the PART IDENTIFICATION CHART on the previous page. Note: Some small parts may have been pre-attached for ship- ping purposes. If a part is not in the parts bag, check to see if it has been pre-attached.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

•One (1) rubber mallet

•Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.Before assembling this product, be sure that you have read and understand the information in the box above.

Tap two 38mm Square Inner Caps (21) into each Upright (1).

Attach the Crossbar (3) to each Upright (1) with four M8 x 57mm Bolts (14), four M8 Washers (12), and four M8 Nylon Locknuts (13). Be sure that the Crossbar (3) and Uprights (1) are ori- ented as shown. The decal must be facing up and the high side of the weight rests must both be on the same side.

2.Tap two 30mm Square Inner Caps (22) into the Front Leg (8).

Attach the Front Leg (8) to the Frame (2) with the M10 x 19mm Bolt (17).

1

		High Side of
	1	Weight Rests
	12	1
14	13
	3	13
	12	12

13

13	14
	12
21
	21
2
2

17

22 8

22

6