ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools (not included) are required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
•Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1.Before assembling this weight bench, be sure that you have read and understand the infor- mation in the box above.
Press two 75mm x 50mm Inner Caps (20) into the ends of an Upright Stabilizer (5).
Attach an Upright (4) to the Upright Stabilizer (5) with two M10 x 65mm Carriage Bolts (41) and two M10 Nylon Locknuts (35). Note: There are indents around the holes on one side of the Upright Stabilizers; this side must be on the bottom.
Assemble the other Upright (4) and Upright Stabilizer (5) in the same manner.
Do not tighten the M10 Nylon Locknuts (35) yet.
Orient the Uprights (4) with the adjustment holes on the outside, as shown.
1
Adjustment
Holes
4 4
35
2035
5
20
20 | 5 |
41
20
41
6