Weider WESY19541 user manual

14.Route the Arm Cable (54) over a “V”-pulley (46). Attach the “V”-pulley, a Large Cable Trap (50), two Full Finger Guards (41), and an M10 Washer

(57)to the Upright (3) with an M10 x 63mm Bolt

(75)and an M10 Nylon Locknut (56). Make sure the Cable Trap is oriented to hold the Cable in the groove of the “V”-pulley.

15.Route the Arm Cable (54) under a 90mm Pulley (48). Attach the Pulley and two Half Finger Guards (43) to the Double “U”-Bracket (63) with an M10 x 46mm Bolt (81) and an M10 Nylon Locknut (56). Make sure the Finger Guards are on the outside of the “U”-bracket as shown.

16.Route the Arm Cable (54) over a “V”-pulley (46). Attach the “V”-pulley, a Large Cable Trap (50), two Full Finger Guards (41), and an M10 Washer

(57)to the Upright (3) with an M10 x 63mm Bolt

(75)and an M10 Nylon Locknut (56). Make sure the Cable Trap is oriented to hold the Cable in the groove of the “V”-pulley.

17.Grease an M8 x 22mm Shoulder Bolt (65). Attach the Arm Cable (54) to the indicated Cable Pivot (39) with the Bolt and an M8 Nylon Locknut (58).

14
	3	56
		41	57	46	50
					41
					75
		54
15
	54
	48	56
	43
		43
	81	63
16	75	41
		50
		57
	46		41
		54			3
					56
17
	Grease 54	39	58
	65

11